When people buy a new house and decorate it, ceramic tiles have always been the first choice for people to choose decoration materials. It not only gives people a sense of high-end, but also carries the ingenuity of the craftsmen. So, when paving and tiling You must pay special attention when laying ceramic tiles. This is also the key to whether the house decoration is good or not. Therefore, it is also a particularly important test for the craftsmen’s laying skills. So when laying ceramic tiles, pay attention topay attention to the laying of ceramic tiles. What are thematters? Let’s find out together!
Let’s take a look at the main points of floor tile paving and wall tile paving as well as the precautions after paving them!
1. Precautions for laying floor tiles
What needs to be noted about floor tiles is that the wall tiles need to be soaked for about 3 hours, but the floor tiles need to be soaked for at least half a day. Similarly, it will be fine if there is no bubbling.
When laying ceramic tiles in kitchens, balconies, and bathrooms, be sure to leave a certain slope at the drain. If the waterproof layer has been prepared, pay attention to the protection of the waterproof layer.
After the floor tiles are laid, cover the tile surface with cardboard, etc., and wait at least 24 hours before walking on the tile surface.
2. Things to note when laying wall tiles
When treating the base layer, all dirt on the wall should be cleaned up and watered one day in advance. If the base layer is a new wall, when the cement mortar is 70% dry, the bricks should be laid out, the threads stretched, and the wall bricks glued.
Before laying ceramic tiles, the tiles need to be fully soaked. The time usually takes about 3 minutes. How to judge whether the tiles are soaked well? Observe the tiles in the water. If there is no bubbling, it means that the tiles have been fully soaked. , now you can take it out for later use.
When gluing pipes, light switches, bathroom equipment supports, etc., they must be cut and matched with whole bricks. It is prohibited to use non-whole bricks to piece together and paste them.
3. Things to note after installing ceramic tiles
After the tiles are laid, the debris on the floor must be cleaned up in time. The cement must be cleaned, and there is excess caulking agent. The caulking agent sticks to the tiles and hardens in a few hours. , it is difficult to clean, so it must be cleaned in time.
Generally, you can only walk on the ground one day after the tiles are pasted. Do not walk on them right after they are pasted. At this time, you need to tap and listen to the sound to identify whether there is any hollow drum.
The above content is what Zhongtaojun shared with you today about Precautions for ceramic tile laying. I hope it will be helpful to you.
(The above pictures are from the Internet, infringement will be deleted)
